SpectraLink 8440 - Page 180

Spectralink 84-Series Series Wireless Telephones Administration Guide
1725-86984-000_P.docx
September 2016 180
Parameter
Permitted Values
Default
apps.push.secureTunnelEnabled
0 or 1
1
If 0, the Web server is not connected through a secure tunnel. If 1, the Web server is connected through a secure
tunnel. To disable the non-secure push (HTTP) requires that both apps.push.secureTunnelEnabled and
apps.push.secureTunnelRequired be set to 0.
apps.push.secureTunnelPort
1 to 65535
443
The port that the handset should use to communicate to the Web server when the secure tunnel is used.
apps.push.secureTunnelRequired
0 or 1
0
If 0, communications to the Web server do not require a secure tunnel. If 1, communications require a secure
tunnel. To disable the non-secure push (HTTP) requires that both apps.push.secureTunnelEnabled and
apps.push.secureTunnelRequired be set to 0.
apps.push.serverRootURL
URL
null
The URL of the application server you enter here is combined with the handset address and sent to the handset’s
browser. For example, if the application server root URL is http://172.24.128.85:8080/sampleapps and the relative
URL is /examples/sample.html, the URL that is sent to the browser is
http://172.24.128.85:8080/sampleapps/examples/sample.html. Can be either HTTP or HTTPS.
apps.push.username
string
null
The user name to access the push server URL.
Note: To enable the push functionality, the parameters apps.push.username and apps.push.password must be set
(not null).
apps.statePolling.password
string
null
Enter the password that the handset requires to authenticate handset state polling.
apps.statePolling.URL
URL
null
The URL to which the handset sends call processing state/device/network information. The protocol used can be
either HTTP or HTTPS. Note: To enable state polling, the parameters apps.statePolling.URL,
apps.statePolling.username, and apps.statePolling.password must be set to non-null values.
apps.statePoling.responseMode
0 or 1
1
The mode of sending requested polled data. If 1, requested polled data is sent to a configured URL. If 0, the data
is sent in the HTTP response.
apps.statePolling.username
string
null
Enter the user name that the handset requires to authenticate handset state polling.
apps.telNotification.callStateChangeEvent
0 or 1
0
If 0, call state change notification is disabled. If 1, notification is enabled.
apps.telNotification.incomingEvent
0 or 1
0
If 0, incoming call notification is disabled. If 1, notification is enabled.
apps.telNotification.lineRegistrationEvent
0 or 1
0
If 0, line registration notification is disabled. If 1, notification is enabled.
apps.telNotification.networkUpEvent
0 or 1
0
If 0, network up notification is disabled. If 1, notification is enabled.
apps.telNotification.offhookEvent
0 or 1
0
If 0, off-hook notification is disabled. If 1, notification is enabled.
apps.telNotification.onhookEvent
0 or 1
0
If 0, on-hook notification is disabled. If 1, notification is enabled.