SpectraLink 8440 - Page 321

Spectralink 84-Series Series Wireless Telephones Administration Guide
1725-86984-000_P.docx
September 2016 321
Parameter
Permitted Values
Default
device.syslog.prependMac
1
0 or 1
0
If 1, the handset’s MAC address is pre-pended to the log message sent to the syslog server.
device.syslog.renderLevel
1
0 to 6
4
Specify the logging level that will display in the syslog. Note that when you choose a log level, you are including all
events of an equal or greater severity level and excluding events of a lower severity level. The logging level you
choose determines the lowest severity of events that will be logged.
0 or 1: SeverityDebug(7). 2 or 3: SeverityInformational(6). 4: SeverityError(3). 5: SeverityCritical(2). 6:
SeverityEmergency(0).
device.syslog.serverName
dotted-decimal IP
address OR
domain name
string
Null
The syslog server IP address or domain name string.
device.syslog.transport
None, UDP, TCP,
TLS
UDP
The transport protocol that the handset will use to write to the syslog server. If set to None, transmission is turned
off but the server address is preserved.
device.usbnet.dhcpServerEnabled
0 or 1
0
If 1, a DHCP Server (which gives out addresses) needs to be started, as opposed to a DHCP Client (which gets an
address).
device.usbnet.ipGateway
1
String
169.254.1.1
The provisioning server IP address.
device.usbnet.subnetMask
1
String
255.255.0.0
The handset’s subnet mask for USBNet.
device.usbnet.enabled
1
0 or 1
1
If 0, USBNet is disabled. If 1, USBNet is enabled.
device.usbnet.ipAddress
1
String
169.254.1.2
The handset’s dotted-decimal IP address on the USBNet interface.
device.wifi.noBkgScanRssi
-100 to 0
-100
This parameter allows the handset to scan during standby in order to locate an AP with a stronger signal. As the
number gets higher, the handset scans more frequently. At -100 the handset will never scan in standby. The -65 to
-75 range will give you periodic scanning and is appropriate for most installations but will need to be tweaked
according to the signal quality in the facility. At -45, the phone will scan constantly and battery life will be impaired.
device.wifi.dhcpEnabled
0 or 1
1
If 0, DHCP is disabled on the wireless interface. If 1, DHCP is enabled on the wireless interface.
device.wifi.dot11n.enabled
0 or 1
1
If 0, 802.11n support is disabled. If 1, 802.11n support is enabled.
device.wifi.enabled
0 or 1
0
If 0, the wireless interface is disabled. If 1, the wireless interface is enabled.
device.wifi.ipAddress
String
0.0.0.0
The IP address of the wireless interface (if not using DHCP).
device.wifi.ipGateway
String
0.0.0.0
The IP gateway address for the wireless interface (if not using DHCP).