Some of the default settings are typically adequate; however, if SNTP settings are
not available through DHCP, you will need to edit the SNTP GMT offset, and
(possibly) the SNTP server address for the correct local conditions. Changing the
default daylight savings parameters will likely be necessary outside of North
America. Disable the local Web (HTTP) server or change its signaling port if the
local security policy dictates (see <httpd/>). Change the default location settings for
user interface language and time and date format (see Time and Date Display).
Modify any settings to match your WLAN and network as needed.
4 Create a master configuration file by performing the following steps:
a Enter the name of each per-handset and per-site configuration files created in steps
2 and 3 in the CONFIG_FILES attribute of the master configuration file
(000000000000.cfg).
b Optional) Edit the LOG_FILE_DIRECTORY attribute of master configuration file so
that it points to the log file directory.
c (Optional) Edit the CONTACT_DIRECTORY attribute of master configuration file so
that it points to the organization’s contact directory.
d (Optional) Edit the USER_PROFILES_DIRECTORY attribute of master configuration
file, if you intend to enable the User Login feature, so that it points to the directory
where user profile files are stored.
e (Optional) Edit the CALL_LISTS_DIRECTORY attribute of master configuration file
so that it points to the user call lists.
5 Perform the following steps to configure the handset to point to the IP address of the
provisioning server and set up the user:
6 On the handset’s Home screen or idle display, select Settings> Advanced Settings>
[enter password]> Administration Settings> Network Configuration> Provisioning
Server> DHCP Menu.
When prompted for the administrative password, enter 456.
a Open the DHCP Server menu by pressing the Select softkey. Set Boot Server to
Static and press to return to the Provisioning Server menu.
b Scroll down to Server Type and ensure that it is set to FTP.
c Scroll down to Server Address and enter the IP address of your provisioning server.
d Press the Edit softkey to edit the value and the OK softkey to save your changes.
e Scroll down to Server User and Server Password and enter the user name and
password of the profile you created on your provisioning server.
In Setting up an FTP Server as Your Provisioning Server the example user given
was bill1234 and the example password was 1234.
f Press the Back softkey twice.
To Next Page
Loading...
