11
i
3. SELECTING/ALTERING BASIC SETTINGS
Note: The settings for each speciality coffee are pre-programmed
before your machine leaves the factory. Your machine is therefore
ready to produce coffee immediately (see Point 4). We recommend,
however, that you take the time to explore and alter the settings to
suit your particular taste. If this is the first time the machine is being
used (see Point 2.4), start by following the instructions outlined in
Points 3.1 to 3.8 below.
3.1 Setting the machine for filter and non-filter operation
3.1.1 Operating with a filter
Filters reduce water hardness, so you will need to descale your
machine less often, provided you install and use this filter properly.
Your machine has been pre-set for non-filter operation (“Filter No”).
Turn the right rotary knob to “Setting”. Now press the right rotary
knob.
Turn the right rotary knob to “Setting Filter”. Now press the right
rotary knob.
Turn the right rotary knob to “Filter Yes”. This tells the machine
that the lter is now in use.
Press the right rotary knob. The “Screw in lter” message
appears on the display.
Empty the water container (Fig. 1/F and Fig. 2) and carefully
screw the lter into its holder inside the water container using
the tool on the end of the measuring spoon (Fig 4).
WARNING! Do not bend or over-tighten the lter.
Fill the container with fresh water to the “maximum” level marker
and put it back into the machine.
Place a suciently large vessel (with a capacity of at least 0.5
litres) under the spout (Fig 1/E) and then press the right rotary
knob.
The machine will now rinse the system. The “Filter is rinsed” message
appears on the display.
Wait a few moments until water is no longer being dispensed
from the spout.
The system will then go through a short heating cycle. The “Setting”
message will appear on the display. The machine is now ready for
use.
Note: Once the machine has been programmed for operation with a
filter, the water hardness settings can no longer be selected. Inside
the machine, water hardness will automatically be set to level 1.
When operating in filter mode, you will need to descale your machine
less frequently. Descaling must ALWAYS be carried out according to
the instructions and ONLY after first REMOVING THE FILTER. The
filter should be replaced after using approx. 50 litres of water.
!
i
3. SELECTING/ALTERING BASIC SETTINGS
To Next Page
Loading...
