36
5. CARE AND MAINTENANCE
Caution: Your machine will display cleaning and maintenance
requests in red text. Respond to this request by turning the
right rotary knob to the respective request (blue text) and then
press the right rotary knob. Follow the further instructions in the
display. See Points 5.1 to 5.5 for more details.
If you want to start cleaning or maintenance programmes even
though no request has appeared, please follow the same steps
described in Points 5.1 to 5.5.
5.1 Rinsing the frothing device
WARNING! Once activated, the rinsing process must not be
interrupted.
We recommend that the frothing device be rinsed out on every
occasion after preparation of any drink containing milk. Rinsing MUST
be carried out, however, when instructions to do so appear on your
display. Proceed as follows:
Turn the right rotary knob to “Setting”. Now press the right rotary
knob.
Turn the right rotary knob to “Care”. Now press the right rotary
knob.
Turn the right rotary knob to “Care Rinse”. Now press the right
rotary knob.
Turn the right rotary knob to “Rinse Frother”. Now press the right
rotary knob.
The messages “Hose to spout” and “and into drip tray” will show
alternately on your display.
Connect the hose to the height-adjustable spout (Fig 7).
Put the free end of the hose into the hole at the back of the drip
tray on the right (Fig 10).
Place a suciently large container (with a capacity of at least 0.5
litres) under the spout.
Now press the right rotary knob.
“Frother is rinsing” now appears on the display. Your machine will
now begin the automatic rinsing process. The rinsing process takes
approximately 20 seconds.
WARNING! The machine will steam during this process. This is
normal.
Once the rinsing cycle is complete, the heating cycle will begin and
your machine is once again ready for operation.
5.2 Rinsing the spout
The spout should be rinsed out regularly. Proceed as follows:
Turn the right rotary knob to “Setting”. Now press the right rotary
knob.
5.CARE AND MAINTENANCE
i
!
!
To Next Page
Loading...
