Sprada TX5 - Cleaning the system

38
5.4 Cleaning the system
Note: When the machine needs cleaning, instructions on how to
proceed will be shown on the display. In order not to compromise
the warranty, please follow these instructions carefully.
WARNING! Look out for the “Please clean” message appearing on
the display. You may continue to obtain drinks from your machine.
Once you have started the cleaning programme, however, it must
not be interrupted. The machine will tell you when to put in a
cleaning tablet.
 Turn the right rotary knob to “Setting”. Now press the right rotary
knob.
 Turn the right rotary knob to “Care”. Now press the right rotary
knob.
 Turn the right rotary knob to “Care Clean”. Now press the right
rotary knob.
 Turn the right rotary knob to “Clean System”. Now press the right
rotary knob.
The “Empty trays” message will appear on the display.
 Remove the drip and used coee trays (Figs 1/L and 1/M) and
empty them.
 If necessary, ll the water container with fresh water, then replace
the water container, drip tray and used coee tray.
The machine will now rinse twice.
The “Cleaning tablet in” and “Powder Chute” messages will now
show alternately on the display.
 Place a suciently large vessel (with a capacity of at least 0.5
litres) under the spout (Fig 1/E).
 Open the lid to the coee powder chute (Fig 1/K).
 Put the cleaning tablet into the powder chute and close the lid.
The “Start Cleaning” message appears on your display.
 Now press the right rotary knob.
Your machine will now begin the cleaning process. The message
“System is cleaning” will appear on your display. The cleaning process
is automatic and lasts approximately 10 minutes.
Once the cleaning cycle is over, the “Empty trays” message appears
on the display.
 Empty the drip and used coee trays (Figs 1/L and 1/M), clean
and replace.
 If necessary, ll the water container with fresh water.
The heating cycle will now begin and the machine will again be ready
for use.
5.CARE AND MAINTENANCE
i
!