Sprada TX5 - Preparing Coffee for the First Time; Switching on after the Machine Has Been Used; Cup Pre-Warming Function

10
2.5 Preparing coffee for the first time
When preparing your first coffee, the coffee grinding chamber will still
be empty. The “Fill beans” message may appear on the display after
the first grinding, indicating that no coffee has been prepared by the
machine.
 In this case, comply with the on-screen instructions and press
the right rotary knob a second time.
The machine will then repeat the process.
2.6 Switching on after the machine has been used
The procedures outlined in Point 2.4 must be carried out before
using the machine for the first time. When using the machine on all
subsequent occasions, proceed as follows:
 Switch on the machine by means of the on/o switch (Fig 1/H).
The “System is heating” message will appear on the display.
Once the machine has reached its operating temperature, the “Please
rinse” message will appear on the display.
 Press the right rotary knob.
The machine will now rinse the system. The machine is now ready for
use. The name of the last drink prepared will appear on the display.
When the machine is to be left unused for long periods (e.g.
during a holiday), switch the machine o using the on/o switch
(Fig 1/H) and disconnect it from the mains supply.
2.7 Cup pre-warming function
Your machine is fitted with a cup pre-warming function. Prior to
preparing your coffee, place your cup on the cup warmer/ holding
plate (Fig 1/I). The machine needs to be turned on for the cup pre-
warming function to operate.
The heat generated is lower in ECO mode.
i
2. GETTING STARTED