Sprada TX5 - Cleaning the frothing device

37
 Turn the right rotary knob to “Care”. Now press the right rotary
knob.
 Turn the right rotary knob to “Care Rinse”. Now press the right
rotary knob.
 Turn the right rotary knob to “Rinse Spout”. Now press the right
rotary knob.
The message “System is rinsing” will appear on your display.
Once the rinsing cycle is complete, the heating cycle will begin and
your machine is once again ready for operation.
5.3 Cleaning the frothing device
WARNING! Once activated, the programme may not be
interrupted.
We recommend that the frothing device be cleaned regularly. Cleaning
MUST be carried out, however, when instructions to do so appear on
your display. Proceed as follows:
 Turn the right rotary knob to “Setting”. Now press the right rotary
knob.
 Turn the right rotary knob to “Care”. Now press the right rotary
knob.
 Turn the right rotary knob to “Care Clean”. Now press the right
rotary knob.
 Turn the right rotary knob to “Clean Frother”. Now press the right
rotary knob.
The messages “Hose to spout” and “end into cleaner” will toggle
alternately on your display.
 Connect the hose to the height-adjustable spout (Fig 7).
 Dissolve the milk cleaning powder (available as an accessory)
in a container with water to make a solution of at least 300 ml.
Follow instructions given in the manufacturer’s instructions.
 Put the end of the hose into the cleaning solution.
 Place a suciently large container (with a capacity of at least 0.5
litres) under the spout.
 Now press the right rotary knob.
Your machine will now begin the cleaning process. The “Cleaning
Activated” message appears on your display.
After a few moments, the messages “Hose to spout” and “and into
drip tray” will show alternately on your display.
 Connect the hose to the height-adjustable spout (Fig 7). Put the
free end of the hose into the hole at the back of the drip tray on
the right. Now press the right rotary knob.
The “Cleaning Activated” message appears on your display.
Once the cleaning cycle is over, the “Empty trays” message appears
on the display.
5.CARE AND MAINTENANCE
!