34
Begin the preparation process by pressing the right rotary knob.
On the display, the “bean symbol” (aroma/strength) ashes rst,
followed by the “ml indication” (amount of coee) in the line below.
You are still able to alter these parameters, while they are ashing.
If you wish to stop preparation of your drink, press the right
rotary knob.
The “Brewing aborted” message then appears on the display.
4.7 Preparing hot water (e.g. for tea)
The standard factory setting for hot water is 150 ml.
“150 ml” will be shown on your display.
In the main menu, turn the right rotary knob to “Water”.
Turn the left rotary knob to change the setting to the amount
required (between 20 and 240 ml).
Important note: Check the size of your cups or glasses. Place a
cup or glass under the spout.
Unless you make any further changes, your machine will use
these settings.
Begin the preparation process by pressing the right rotary knob.
Note: If you began preparation too early, or have made a selection
error, you can still change some of the parameters whilst your hot
water is being prepared. The “ml symbol” will be ashing on the
bottom row of your display.
Turn the right rotary knob to the required setting.
If you wish to stop preparation of your drink, press the right
rotary knob.
4.8 Setting the coee grinder
WARNING! The coee grinder must only be reset while grinding
is in operation.
The grinding operation can be set to match the type of coee beans
used. We recommend that you always leave the coee grinder setting
on medium.
In order to adjust the coee grinder setting, proceed as follows:
Open the service door on the right of the machine housing (Fig
1/J).
The coee grinding regulator is located in the top right-hand corner
(Fig 9).
Place a cup under the coee spout (Fig 5).
In the main menu, turn the right rotary knob to “Espresso”.
Now press the right rotary knob.
While grinding is in progress, move the regulator to alter the
degree of grinding (Fig 9).
i
i
!
4. PREPARING SPECIALITY COFFEES
To Next Page
Loading...
