26
Note: Your machine cannot be programmed to prepare more than
one cup of any drink containing milk.
Place your cup centrally under the spout (Fig 5).
Begin the preparation process by pressing the right rotary knob.
Note: If you began preparation too early, or have made a selection
error, you can still change some of the parameters while your
drink is being prepared. These parameters are shown on the
bottom row of the display. While they are ashing, you still have
time to alter them.
Turn the right rotary knob to the required setting.
On the display, the “bean symbol” (aroma/strength) ashes rst,
followed by the “ml symbol” (rst for the amount of froth, then for the
amount of coee). You are still able to alter these parameters, while
they are ashing.
If you wish to stop preparation of your drink, press the right
rotary knob.
The “Brewing aborted” message then appears on the display.
4.4 Preparing a Latte Macchiato
The standard factory settings for Latte Macchiato are: Volume 300 ml,
Aroma “Normal”.
Your display will show this information as follows: “300 ml ”.
The special frothing device allows you to directly transfer milk to your
cup or glass from any type of milk container.
Connect the hose to the height-adjustable spout (Fig 7).
Put the other end of the hose into your milk container (see milk
container in Fig 8).
WARNING! Once dry, milk residue can be dicult to remove.
Please clean your equipment thoroughly immediately after it has
cooled down. Always follow the instructions given in the “Rinse
frother” menu item on your display.
Your Latte Macchiato can be prepared in two ways:
1. You can select the standard settings from the “Recipe” menu.
These are the factory settings. However, you can change these
settings, as described below.
2. Or you can change the setting to suit your personal taste while
making your individual preparation. The standard settings
then remain unchanged.
i
i
!
4. PREPARING SPECIALITY COFFEES
To Next Page
Loading...
