Sprada TX5 - Setting the Temperature

13
Note: If there are no red dots on the strip, set your machine to
level 1.
Set your machine for water hardness as follows:
 Turn the right rotary knob to “Setting”. Now press the right rotary
knob.
 Turn the right rotary knob to “Setting Water Hardness”. Now
press the right rotary knob.
The current water hardness setting will appear on the display.
 Now press the right rotary knob.
The machine’s current water hardness setting will ash intermittently
on the display screen.
 Turn the right rotary knob to select the required water hardness
level. Now press the right rotary knob.
 Turn the right rotary knob to “Water Hardness Exit”. Now press
the right rotary knob.
The “Setting Water Hardness” message will appear on the display.
 Turn the right rotary knob to “Setting Exit”. Now press the right
rotary knob.
The first menu level will appear on the display. The machine is now
ready for use.
3.3 Setting the temperature
Coffee temperature can be set to “normal”, “high”, “maximum” or
“individual”, to suit your personal requirements. The standard factory
setting is “high”. Once you have set the temperature, as described
below, this will be the setting used for all speciality coffees.
Alternatively, you can use the “individual” setting to allow you to
select a different temperature for each speciality coffee (see Point 4).
Choose the “individual” setting in this menu as follows:
 Turn the right rotary knob to “Setting”. Now press the right rotary
knob.
 Turn the right rotary knob to “Setting Temperature”. Now press
the right rotary knob.
The current temperature setting will appear on the display.
 Now press the right rotary knob.
The current temperature setting will flash intermittently on the display
screen.
 Turn the right rotary knob to select the required temperature
setting. Now press the right rotary knob.
 Turn the right rotary knob to “Temperature Exit”. Now press
the right rotary knob. The “Setting Temperature” message will
appear on the display.
 Turn the right rotary knob to “Setting Exit”. Now press the right
rotary knob.
The first menu level will appear on the display. The machine is now
ready for use.
3. SELECTING/ALTERING BASIC SETTINGS
i