41
i
Remove the cover plate (Fig 1/N) from the adjustable spout unit.
Pull out the frothing device (Fig 11b) and dismantle it into its
component parts (Fig 1/P).
Clean the individual parts (Fig 1/P) thoroughly and then
reassemble the unit.
Place the frothing device into your machine (Fig 11a).
Place the cover plate onto the adjustable spout unit (Fig 1/E).
Note: Your machine is fitted with castors (Fig 1/O). These allow
the machine to be easily moved on a level working surface. This
also helps you keep the area under the machine clean.
5.7 Cleaning the brewing unit
WARNING! Only remove the brewing unit when the machine is
switched o!
To clean the unit, remove it from the machine and hold it under cold
running water. Do not use any cleaning agent. Only use clean water.
In the interests of hygiene, we recommend that you always remove
and thoroughly clean the brewing unit after running the cleaning
programme (see Point 5.4.).
Open the service door on the right of the machine housing (Fig
1/J).
Unlock the brewing unit by pressing the red button and turning
the handle all the way to the left until it clicks into place (Fig 12).
Carefully pull out the brewing unit using the handle.
Clean the unit under running water and allow it to dry.
Carefully replace the unit and lock it into position by holding
down the red button and turning the handle all the way to the
right until it clicks into place.
Close the service door, making sure that the door studs engage
in the slots provided. Then press the door gently until it clicks
into place (Fig 1/J).
5.8 Changing the water lter
The filter should be replaced after using approx. 50 litres of water. The
“Change Filter” message appears on the display.
You may continue to obtain drinks from your machine. We recommend,
however, that you replace the filter immediately.
Turn the right rotary knob to “Setting”. Now press the right rotary
knob.
Turn the right rotary knob to “Setting Filter”. Now press the right
rotary knob.
Turn the right rotary knob to “Filter Yes”. This tells the machine
that the lter is now in use.
Now press the right rotary knob. The “Change Filter” message
appears on the display.
5.CARE AND MAINTENANCE
!
To Next Page
Loading...
