Sprada TX5 - Troubleshooting

44
FAULT MEANING WHAT TO DO
No hot water or steam
prepared
Frothing device (Fig 1/P) blocked  Dismantle frothing device and
clean thoroughly (Fig 1/P)
Too little froth Possible lime scale buildup in
system
 Descale using max. dosage
(Point 5.5)
Unsuitable milk  Use cold milk
Frothing device is blocked  Dismantle frothing device and
clean thoroughly (Fig 1/P)
Coee only issues from
spout in drips
Possible lime scale buildup in
system
 Descale using max. dosage
(Point 5.5)
System possibly dirty  Clean system (Point 5.4)
Grinder setting too ne  Set grinder coarser (Point 4.8)
Coee powder too ne  Change coee type
Coee has no crema Possible lime scale buildup in
system
Unsuitable coee type
 Descale using max. dosage
(Point 5.5)
 Change coee type
Grinder noisy Beans not fresh  Use fresh beans
Grinder settings not suited for
bean type
 Optimise Grinder settings
Foreign body (e.g. grit) in grinder  Call service centre, meanwhile
pre-ground coee can be used
In the event of being unable to correct a fault or malfunction, or not being able
to clear a fault message, call a SPRADA customer service centre.
Malfunctions ascertained by the system appear on the display as fault
messages with a fault message/number.
Attention: Please ensure that you make a note of the fault
message. Switch o the machine and disconnect it from the
mains supply. Note the model, serial number (see Identication
Plate, Fig 1/Q) and fault message. Our customer service centre
will then advise you on how to proceed.
7. TROUBLESHOOTING
7. TROUBLESHOOTING
!