9
Place a suciently large vessel (with a capacity of at least 0.5
litres) centrally under the spout.
Press the right rotary knob.
The machine will now fill the system.
The “Please rinse” message will appear on the display, once the
system has reached its operating temperature.
Press the right rotary knob.
2.4.2 Setting water hardness
Sooner or later (depending on local water hardness conditions),
your machine will require descaling. In order for the machine to tell
you when descaling is necessary, you must select the correct water
hardness setting before using the machine for the first time.
When using a filter, provided the correct settings have been made (see
above), water hardness will automatically be set inside the machine
to level 1. Before leaving the factory, water hardness is set to level 3.
Start by testing the quality of the water to be used in your machine
with the test strip provided.
Dip the test strip briey into your water sample and then shake
o any excess water.
Wait for approximately one minute and then take your reading by
counting the red dots on the test strip.
The level settings are indicated as follows:
Test Strip / Degree of Hardness = Display
1 red dot/1–7° = LEVEL 1
2 red dots/8–14° = LEVEL 2
3 red dots/15–21° = LEVEL 3
4 red dots/>21° = LEVEL 4
Note: If there are no red dots on the strip, set your machine to
level 1.
Set your machine for water hardness as follows:
Turn right rotary knob to select settings.
Press right rotary knob to enter settings.
Turn the right rotary knob to select the water hardness level.
Press the right rotary knob to confirm your selection.
The “Please rinse” message now appears on the display.
Now press the right rotary knob.
The system is now filled with water.
Once the machine has reached its operating temperature, the display
will automatically return to the first menu level. The machine is now
ready for use.
i
2. GETTING STARTED
To Next Page
Loading...
