8
Fill the container with fresh water to the “maximum” level marker
and put it back into the machine.
Place a suciently large vessel (with a capacity of at least 0.5
litres) under the spout (Fig 1/E) and then press the right rotary
knob.
The machine will now rinse the system. The “Filter is rinsed” message
will appear on the display.
Wait a few moments until water is no longer dispensing.
The “Please rinse” message now appears on the display.
Press the right rotary knob.
The machine will rinse and will then be ready for use.
Note: Once the machine has been programmed for operation with
a lter (“Filter Yes”), the water hardness settings can no longer be
selected. Inside the machine, water hardness will automatically
be set to level 1. When operating in lter mode, you will need to
descale your machine less frequently. Descaling must ALWAYS
be carried out according to the instructions and ONLY after rst
REMOVING THE FILTER. Filters should be replaced after using
approx. 50 litres of water (for details on lter replacement, see
Point 3.1.1).
WARNING! Even when the machine is not in regular use, lters
should be replaced at least every 2 months (see Point 3.1.1).
Do not wait for the “Change Filter” message to appear on the
display.
Using the machine without a lter
If the machine is to be operated without a lter, it must be reset to
the “Filter No” mode. This is important because, depending on local
water hardness, operating without a lter will require the machine to
be descaled more frequently (the machine is pre-set in the factory for
“Filter No” operation).
Turn the right rotary knob to “Filter No”.
Press the right rotary knob to conrm your selection.
The “Setting Water Hardness” message will appear on the display.
Note: When using the machine for the rst time, the water circuit
may still be empty. In this case, the “Fill System” message will
appear on the display when the machine is rst activated by
means of the on/o switch (Fig 1/H).
i
i
!
2. GETTING STARTED
To Next Page
Loading...
