ST500 Tach-Timer Operation
© Stack Limited
33
display change:
The distance shown continues to increase as
the vehicle moves, until the driver presses the
Driver button again to mark the second Split
distance marker.
This procedure sets both split marker distances
in the Setup Menu. You can follow the
instructions to set the split distances manually
if you need to adjust them.
Use the Automatic Split Setup feature to measure the split distances when
you first visit and use a track. Before you leave the track, note the split
distances and then enter these distances manually during future visits to
the same track. This helps to ensure repeatability from one visit to the
next.
Hillclimb and Sprint Operation
To remove the requirement for a beacon at the start and finish line, your
Tach–Timer has an ‘arming’ feature. This allows you to set the Tach–Timer
so that it starts timing from the instant when the wheels begin to move.
You will need a functioning wheel speed sensor to use this feature.
Press both buttons from the normal display
mode. The next time the vehicle starts moving,
the Tach-Timer will record a lap mark. If the
To Next Page
Loading...
Need help?
General
