ST700 Dash Display SystemMemory and Setup
© Stack
57
Select whether the RPM gate, described on page 53, is enabled or dis-
abled.
❑ Battery Input—Press the rotary control briefly to see the current
setting for the battery alarm. Press and turn the control to set the
battery voltage below which the alarm pop–up will appear. You
may also set the RPM gate for the battery voltage alarm.
❑ Lap Time Input—Press the rotary control briefly to see the current
setting for Lap Masking. Press and turn the control to adjust the set-
ting. You will disable the lap masking feature if you set the value to
zero.
The infrared lap timing system supplied by Stack uses a coded infra-
red frequency that is common to all Stack lap timing systems. This
feature allows users of Stack systems to share a common beacon at
each circuit, and ensures that the ST700 Dash Display System will
not be triggered by other manufacturers’ timing beacons.
The lap masking feature allows you to make certain that your system
does not pick up signals from incorrectly placed Stack beacons that
could trigger a false lap time. Typically, you should set the lap mask-
ing time to 50% of an anticipated lap time.
To Next Page
Loading...