5.2.5. Charts
Values displayed on the
charts
Button functions
5.2.5. Charts
Button Chart of the main window opens a window for working with charts.
XILab Charts window
In the left part of the window there are Charts of variables, in the right side of the window there is the Control block, which contains
the charts control elements. Above the Control block there are flags which enable different charts, below the Control block there is a
group of buttons to control the stored charts data.
Values displayed on the charts
Position is the primary field in which the current position is stored, no matter how feedback is arranged. In the case of a DC-
motor this field has the current position according to the encoder, in the case of a SM (stepping motor) this field contains the
current position in steps;
Speed is the current speed;
Encoder is the position according to the secondary position sensor;
Power voltage is voltage of the power section;
Power current is current consumption of the power section;
USB voltage is voltage on the USB;
USB current is current consumption by USB;
Winding A current - in the case of stepper motor, the current in winding A; in the case of a brushless motor, the current in the
first winding and in the case of DC motor, the current in its only winding;
Winding B current - in the case of stepper motor, the current in the winding B; in the case of brushless motor, the current in the
second winding, unused in the case of DC motor;
Winding C current - in the case of a brushless motor, the current in the third winding, unused in the case of DC or stepper
motor;
Winding A voltage - in the case of stepper motor, the voltage on winding A; in the case of a brushless motor, the voltage on the
first winding and in the case of DC motor, the voltage on its the only winding;
Winding B voltage - in the case of stepper motor, the voltage on the winding B; in the case of brushless motor, the voltage on
the second winding, unused in the case of DC motor;
Winding C voltage - in the case of a brushless motor, the voltage on the third winding, unused in the case of DC or stepper
To Next Page
Loading...