TUP500 Series Product Specifications 8-14
Supporting 82.5 mm paper width
Position the notched portion of the friction spring to the guides a and a’ shown in Fig. 8.3.1.A., and use the screw
holes B and B’ so that the central position of the notch is not mis-positioned with the central position of the guide
as shown in Fig. 8.3.1.B. Fasten the friction spring using the M3 screw.
Supporting 79.5 mm paper width
Position the notched portion of the friction spring to the guides b and b’ shown in Fig. 8.3.1.A., and use the screw
holes B and B’ so that the central position of the notch is not mis-positioned with the central position of the guide
as shown in Fig. 8.3.1.C. Fasten the friction spring using the M3 screw.
Fig. 8.3.1.B .
Position the notch on
the scale
Position the notch on
the scale
Fig. 8.3.1.C .
Position the notch on
center of the scale
Position the notch on
center of the scale
To Next Page
Loading...
