TUP500 Series Product Specifications
8-15
Supporting 57.5 mm paper width
Position the notched portion of the friction spring to the guides c and c’ shown in Fig. 8.3.1.A., and use the screw
hole A so that the central position of the notch is not mis-positioned with the central position of the guide as shown
in Fig. 8.3.1.F. Fasten the friction spring using the M3 screw.
Supporting 45 mm paper width
Position the notched portion of the friction spring to the guides d and d’ shown in Fig. 8.3.1.A., and use the screw
hole A so that the central position of the notch is not mis-positioned with the central position of the guide as shown
in Fig. 8.3.1.E. Fasten the friction spring using the M3 screw.
Fig. 8.3.1.D .
Position the notch on
the center of the scale
Fig. 8.3.1.E .
Position the notch on
the center of the scale
Position the notch on
the center of the scale
To Next Page
Loading...
