Starcom Systems Helios - Appendix H: Using Keypad with RF Relay

Helios Users Guide
www.starcomgpsglobal.com 152
Appendix H – Using Keypad with RF Relay
You can use an external RF relay (up to 3 units), which will be activated by a
keypad code, to perform the immobilizer functions.
Configuration
In Installer application, go to Helios Parameters > Outputs, enable the Use
keypad RF instead of Immobilizer output option.
Select Immobilizer On when Armed, if you’re using a Normally Closed relay.
Select Immobilizer On when Idle, if you’re using a Normally Open relay.