Helios Users Guide
www.starcomgpsglobal.com 47
Outputs settings
This tab allows you to configure the unit outputs activities and alerts.
Locking – activates the settings for Helios Door Lock output.
Unlocking – activates the settings for Helios Door Unlock output.
Pulses – number of pulses to send in order to lock/unlock the vehicle.
Width (s) – width of pulses
Interval (s) – interval between the pulses, if there is more than one pulse.
For more information, see Appendix C – Central Locking System Configuration.
Immobilizer – activates the settings for Helios Immobilizer output.
On when Armed / Idle – the condition in which the unit will activate its
immobilizer output. When connected using a Normally Open relay, this value
should be set to Idle. When using a Normally Closed relay, set to Armed.
Use keypad RF instead of Immobilizer output – used instead of immobilizer,
when keypad is used to transmit driver codes to wireless relays. For more
information, see Appendix H – Using Keypad with RF Relay.
To Next Page
Loading...
