Helios Users Guide
www.starcomgpsglobal.com 49
Logic settings
This tab allows you to configure the unit logic states.
Auto (Un)Lock from Ignition – if activated, the unit will send a lock signal
when the ignition is turned on, and unlock when it is turned off.
GPS Off When Ignition Off – if enabled, turns the GPS off when the ignition is
off. This helps to avoid the unit reporting vehicle movement, which can be
caused by GPS "jumps", when it is actually stopped.
Transmit after first start-up or restart – if activated, a Power On message
will be transmitted whenever the unit is either powered on for the first time, or
restarted.
The unit remains in one of its logic states at all times. The logic state can be
changed automatically, according to the parameters configured in this tab, or
manually, by using remote control, keypad, iButton, or over-the-air command.
The following are the unit logic states:
Idle – unit state when the engine is on.
Armed – the immobilizer is activated and the engine is off. The alarm
system is active and ready.
Garage – the alarm system is disabled for a predefined period of time.
This is useful, for example, when the vehicle is undergoing maintenance.
To Next Page
Loading...
