Catalog
Safety
Chapter 1 controller general introduction
1-1 Installation dimension
1-2 display
1-3 keys
1-4 USB port
1-5 Switch power supply
1-6 Replays
1-7 Signal ports
Chapter 2 parts load
2-1 load from Figures
2-2 load from disk
2-3 load from Edit
2-4 restore parts cutting
Chapter 3 parts nest
3-1 rotation
3-2 mirror
3-3 scale
3-4 array
3-5 nest
Chapter 4 parts cutting
4-1 auto interface, figures display, operation display, state display
4-2 manual interface
4-3 preparation before cutting, cutting mode, speed limitation, kerf
4-4 optional operation, torch movement, return, reset (fixed point), parts alignment, outline, simulation, start
point change, section, manual output
4-5 operation during cutting
4-6 operation after pause
Chapter 5 Settings
5-1 speed
5-2 system
5-3 control
5-4 craft
5-5 figure
5-6 machine
5-7 configuration
5-8 advanced parameter management
To Next Page
Loading...