Start Shaphon CC-M3 - Circle; High (Advanced) Parameter

5
Pneumatic Lifting
1 use, 0 don’t use. When use, arc strike and pierce keep torch down output
during cutting
6
Zero Point Switch
1 use, 0 don’t use. Moving method when manual reset
Circle
1
The First Arc
Set small circle 1 speed limitation, diameter ≤ the value hole, cutting speed is
limited within the speed value
2
The Second Arc
Set small circle 2 speed limitation, diameter ≤ the value, and > small circle 1
value hole, cutting speed is limited within the speed value
3
The Third Arc
Set small circle 3 speed limitation, diameter ≤ the value, and > small circle 2
value hole, cutting speed is limited within the speed value
High (advanced) parameter