Speed limitation
1. L1: set cutting speed.
2. Multi-functional knob, turn it to adjust speed rate.
3. F+/F- to adjust.
In auto interface, under pending state, press “0” to check and revise “idle-run speed”, “cutting speed”,
“manual speed” and “back speed”.
Note: the adjusted speed rate will be recorded till adjust next ime.
Kerf
In auto interface, under pending state, press L2 to revise kerf, set value is a half of the actual kerf width,
unit:mm.
4-4 other operations before cut
Move torch
Press F1 to manual interface
To Next Page
Loading...