Start Shaphon CC-M3 - Move Parts; Change Parts Sequence

71 pages

Save Page as PDF

To Next Page

To Previous Page

Change parts sequence

After add parts, change cutting sequence by “Front” and “Back”, press F7 to refresh.

Move parts

After add parts, choose them by direction buttons, press F5 to move, press L4 to set movement distance.

Main Page

Catalog2
Safety Notice4
Safety Operation4
Mechanical Dangerousness4
High-Voltage Dangerousness4
Controller Operation and Maintenance5
Controller Operation5
Controller Maintenance5
Declaration5
Controller General Introduction6
Installation Dimension (same as Model SH-2200H)6
Basic Parameters6
Display7
CC-M3C7
Keys9
Fast Operation9
USB Port11
Power Switch11
Emergency Stop Switch11
Back Panel11
Signal Port12
Input Principle Diagram13
Input Signal Port Definition13
Output Signal Port Definition14
Communication Signal Port15
Motor Signal Port15
Motor Signal Port Definition17
Load Parts18
Load from Figure18
Load from Disk19
Load from Edit21
Restore Part Cutting21
Record Rule22
Array Parts22
Rotate22
Mirror23
Scale24
Nest25
Move Parts31
Change Parts Sequence31
Rotate Parts32
Save Nesting Parts Program33
Cut Parts34
Auto Interface34
Figure Display Area35
Set Figure35
Manual Interface36
Preparation before Cut36
Highlight Means Turn on36
Speed Limitation37
Kerf37
Other Operations before Cut37
Move Torch37
Manually Adjust Torch to Specified Position38
Return38
Reset39
Align Parts (Plate Calibration)39
Outline39
Simulation Run40
Change Start Point41
Section41
Flame Mode43
Auto Cutting43
Pause During Auto Cutting44
Start after Path Deviate46
Input Port47
Setup48
Speed48
System49
Adjustment Method50
Coordinate Setting Reference Diagram50
Control51
Craft52
Flame52
Flame Cutting Procedure54
Plasma55
Plasma Cutting Procedure58
Mach (Machine) Parameters59
Circle60
High (Advanced) Parameter60
Edit Function61
Codes Instruction61
G Command (Basic Prepare Command)62
Coordinate System62
G90/G9162
G20/G21 British System/ Metric System Instruction63
G00 Point Movement63
G01 Straight Line Cut63
G02/G03 Arc Cut64
Current Torch Position64
G04 Pause / Delay Command65
G26, G27, G28 Back to Reference Point65
G22/G80 Loop Statement65
G4065
M Assistant Function66
M08 Turn off Cut Fixed Loop66
Plasma Cut Operation as below66
M50 Pierce66
M52 Ignition Fixed Cycle67
M70 Torch up Fixed Cycle67
M71 Torch down Fixed Cycle67
M72 Pierce Torch up Cycle67
File Manager67
F3 Preview Current Parts Figure68
Diagnose69
F4 Search Parts69
Input70
Output70
Adjust Moving Precision71
Controller Upgrade71
Special Setting after Turn on the Controller71

Start Shaphon CC-M3 - Move Parts; Change Parts Sequence

Table of Contents