Stihl FSA 130 R - Battery Safety; Warnings and Instructions; Battery Recycling

0458-725-8621-B
19
English 5 IMPORTANT SAFETY INSTRUCTIONS
5.8.2 Using a Mowing Head
► When working, sweep the trimmer in a controlled manner,
parallel to the ground in front of you.
Mowing heads are to be used only on units equipped with a
line-limiting blade in the deflector in order to keep the line at
the proper length. When trimming along a fence, wall or
around trees, it is preferable to use a mowing head with
nylon line to reduce the risk of blade thrust or kickout,
damage to the cutting attachment, and to reduce damage to
the fence, wall or trees.
WARNING
￭ To reduce the risk of serious injury:
– Never use wire or metal-reinforced line or other
material in place of the recommended nylon cutting
line. Pieces of wire could break off and be thrown at
high speed toward the operator or bystanders.
￭ A cracked, damaged or worn out mowing head may
shatter at high speeds and cause serious or fatal injury.
– Have a cracked, damaged or worn out mowing head
replaced immediately, even if damage appears to be
limited to superficial cracks.
￭ When working close to fences, sides of buildings, tree
trunks of other such objects, be alert to an increased
possibility of ricochets.
5.8.3 Using a Grass Cutting Blade
► When working with a grass cutting blade, sweep the
trimmer in a controlled manner, parallel to the ground in
front of you. To reduce the risk of kickout, use the left side
of the cutting blade.
All kinds of grass and weeds can be cut with a grass cutting
blade.
– The 4-tooth grass cutting blade is intended to cut grass
and weeds. It has 4 cutting knives with cutting edges on
both sides, i.e., front and rear. When the cutting edges on
one side become dull, the blade can be turned over to
utilize the cutting edges on the other side.
– The 8-tooth grass cutting blade is recommended for
cutting fern or similar fleshy vegetation. When the cutting
edges on one side become dull, the cutting edges have to
be resharpened. The blade cannot be turned over to
utilize the cutting edges on the other side.
0000-GXX-3800-A0
– Take care to clear area of all objects and
debris before trimming along fences or
walls, near tree trunks or other objects
that could increase the possibility of
injury from the ricochet of thrown objects.
0000-GXX-3801-A0