Stihl FSA 130 R - STIHL Battery Backpack; Mounting the AP Battery Bag with Connecting Cord inside the Battery Backpack

0458-725-8621-B
33
English 12 Using a Battery Harness
► Screw on the nut(1) counterclockwise and tighten it down
until the cutting attachment is properly and securely
attached.
► Remove the stop pin from the hole in the gearbox.
Cutting attachments with more than 4 cutting edges must be
mounted with the cutting edges pointing in the direction of
rotation. Otherwise, the cutting attachment will not cut. The
direction of rotation is indicated by an arrow on the
underside of the deflector.
NOTICE
Arrows on the deflector (A) (as seen from the underside)
show the correct direction of rotation of the cutting
attachment. When viewed from above, however, the cutting
attachment rotates counterclockwise.
NOTICE
After mounting or removing the cutting attachment, always
remove the stop pin used to block rotation of the drive shaft.
11.6.2 Removing a Metal Cutting Attachment
To remove a metal cutting attachment:
► Switch off the power tool, @ 15.2.
► Remove the connecting cord, @ 14.2.
► Position the unit so that you are facing the underside of
the deflector and the drive shaft is pointed upwards.
► Block the rotation of the drive shaft with the stop pin.
► Unscrew the nut by turning it clockwise.
► Remove the rider plate, thrust washer, metal cutting
attachment and thrust plate.
► Remove the stop pin from the hole in the gearbox.
NOTICE
After mounting or removing the cutting attachment, always
remove the stop pin used to block the rotation of the drive
shaft.
12.1 STIHL AR Backpack Battery
12.1.1 Positioning and Adjusting the Connecting Cord
WARNING
To reduce the risk of injury from tripping or losing control of
the power tool, always secure the connecting cord through
the backpack guides and with the hook and eye fasteners as
described below. Position and secure the connecting cord
so that it will not interfere with proper working technique or
your ability to maintain control of the trimmer / brushcutter.
WARNING
Manage the cord to prevent it from contacting the cutting
attachment or catching on objects, which could cause you to
lose balance or control of the trimmer / brushcutter, resulting
in serious personal injury and property damage.
The connecting cord can be secured in different positions
and adjusted to suit the height and reach of the operator.
0000-GXX-3919-A0
A
12 Using a Battery Harness