Stihl FSA 130 R - Mounting and Removing a Metal Cutting Attachment; Mounting a Metal Cutting Attachment

0458-725-8621-B
30
English 11 Assembling the Trimmer / Brushcutter
To remove the skirt from the deflector:
► Insert the stop pin(2) in the hole in the skirt.
► Slide the skirt(1) off the guide ridge at the bottom of the
deflector.
11.5 Mounting and Removing a Mowing Head
11.5.1 Mounting a Mowing Head
WARNING
Use of wire or metal-reinforced line is not authorized and
could be extremely dangerous. Use only the cutting
attachments recommended in this manual, in combination
with the recommended deflector, @ 5.7.4.
WARNING
A damaged or loose cutting attachment or mowing head may
vibrate, crack, break or come off the trimmer / brushcutter,
which may result in serious or fatal injury or property
damage. Make sure the mowing head and cutting
attachment are properly tightened and in good condition
before starting work, @ 5.7.4.
Mowing heads other than FixCut 31-2
To mount a mowing head:
► Switch off the power tool, @ 15.2.
► Remove the connecting cord, @ 14.2.
► Position the unit so that you are facing the underside of
the deflector and the drive shaft is pointed upwards.
► Slip the thrust plate(2) onto the drive shaft(3), keeping
the side of the thrust plate with the smaller diameter facing
upwards toward the mowing head(1).
► Insert the stop pin(4) in the hole in the gearbox and rotate
the drive shaft until the stop pin slips into position and
blocks the rotation of the drive shaft.
► By hand, screw the mowing head counterclockwise onto
the drive shaft while keeping the stop pin inserted. The
drive shaft must be blocked with the stop pin to mount or
remove a cutting attachment.
► Continue screwing down the mowing head until it is
properly and securely attached.
► Remove the stop pin from the hole in the gearbox.
FixCut31-2 Mowing Head
To mount the FixCut31-2 mowing head:
► Switch off the power tool, @ 15.2.
► Remove the connecting cord, @ 14.2.
1
0000-GXX-3030-A2
2
2
3
4
0000-GXX-3031-A0
1
4
1