Stihl FSA 130 R - Removing a Mowing Head

0458-725-8621-B
29
English 11 Assembling the Trimmer / Brushcutter
WARNING
The cutting attachment and deflector must be an approved
combination. Use only an approved combination of cutting
attachment and deflector to maximize cutting performance
and reduce the risk of serious personal injury from thrown
objects or contact with the cutting attachment, @ 25.
All deflectors are mounted to the gearbox in the same way.
To mount a deflector:
► Switch off the power tool, @ 15.2.
► Remove the connecting cord, @ 14.2.
► Push the deflector(1) into the guides on the gearbox until
it stops. The deflector must be tight against the gearbox.
► Insert and tighten the screws(2). Ensure that the deflector
is tight and will not move during operation.
To mount the skirt and line limiting blade:
► Insert the guide ridge on the bottom of the deflector(1)
into the groove on the skirt(2).
► Slide the skirt until it covers the entire bottom of the
deflector and clicks into place.
When the skirt is properly installed, it will cover the
pictogram embossed on the deflector indicating that use
with mowing heads is prohibited.
► Push the line limiting blade(3) into the guide groove of the
skirt.
► Insert and tighten the screw(4) until the line limiting blade
is securely in place.
11.4.2 Removing a Deflector
To remove a deflector:
► Switch off the power tool, @ 15.2.
► Remove the connecting cord, @ 14.2.
► Remove the screws(2).
► Remove the deflector(1)
1
2
0000-GXX-3027-A0
3
2
4
0000-GXX-3028-A1
1
0000-GXX-3029-A0
1
2