Stihl MS 240 User Manual

117MS 240, MS 260, MS 260 C
No. Description Part No. Application Rem.
28 Service tool AS (set) 5910 007 2205 Removing and installing crankshaft
(clutch side)
- Installing tool 5910 890 2205 Pulling two halves of crankcase
together
- Screw sleeve 5910 893 2409 Pulling two halves of crankcase
together
29 Service tool ZS (set) 5910 007 2200 Removing and installing crankshaft
(ignition side)
- Washer 5910 893 2101 Installing crankshaft
- Screw sleeve 5910 893 2421 Installing crankshaft
30 Press arbor 1118 893 7200 Removing and installing ball bearings
31 Press arbor 1120 893 7200 Removing and installing ball bearing
(clutch side)
32 Assembly tube 1117 890 0900 Attaching springs
33 Stud puller M8 5910 893 0501 Removing bar mounting studs
34 Installing tool 0000 890 2201 Installing rope guide bushing
35 Hook 5910 893 8800 Removing pickup body
36 Torque wrench 5910 890 0302 0.5 to 18 Nm
37 Torque wrench 5910 890 0312 6 to 80 Nm
38 Screwdriver bit, T 27 x 125 0812 542 2104 Removing and installing spline socket
screws with electric or pneumatic
screwdrivers; tightening down screws
with torque wrench
39 Screwdriver bit, T 27 x 150 5910 890 2400 IS-P screws (4 mm)
40 Crimping tool 5910 890 8210 Attaching connectors to electrical wires
41 Pliers DIN 5254-A 19 0811 611 8380 Removing and installing external
circlips
Remarks:
1) Use for releasing only.

Stihl MS 240 Specifications

General

Chain pitch	3/8"
Oil Capacity	0.2 L
Guide bar length (recommended)	40 cm
Engine Power	2.0 kW (2.7 bhp)
Displacement	41.6 cm³