Online version - not for reprint
27MS 341, MS 361, MS 361 C
: Attach the coasting brake
cable (1) to the hole (arrow) in the
brake lever (2).
VA
148RA075
2
: Position bearing boss of the hand
guard (1) against the pivot pin
and fit the other side of the hand
guard over the fan housing.
: Press the hand guard (1)
carefully downward, and push
the brake lever (2) onto its pivot
VA
212RA026
1
3
2
pin (3) at the same time.
Coat all sliding and bearing points
with STIHL multipurpose grease –
b 16.
– Lubricate the new brake band
with a few drops of chain oil.
: Attach the spring (1) to the pivot
pin.
VA
212RA027
1
: Fit the screw (arrow) and tighten
it down firmly – b 3.5
VA
212RA021
: Attach the brake band (1) to the
brake lever (2) and then push it
into the slot in the crankcase
(arrow).
VA
212RA020
1
2
: Fit the screw (arrow) and tighten
it down firmly – b 3.5
VA
212RA025
: Turns of brake spring must be
tightly against one another in the
relaxed condition. If this is not the
case, replace the brake spring.
: Check correct position of
protective tube:
aa
b
VA
176RA046
a = 31 mm
b = 44 mm
To Next Page
Loading...
