2 Safety
Intended use
Intended use
These industrial trucks are intended for
use in order picking applications, i.e. for
collecting parts that are stored in racking
systems, for example. This industrial truck is
therefore designated as a vertical order picker.
The forks must be equipped with suitable
load-carrying equipment in order to set down
the parts picked for the order. This process
is described in the section entitled Picking up
and setting down loads.
The industrial truck is not suitable for stacking
and unstacking unit loads in storage systems.
DANGER
Risk of serious injury or death
When driving underneath solid structures (e.g.
rack bridge pieces, transfer stations or crossbars),
there is a risk that the operator may be crushed
between the racking and the operating panel and
be fatally injured. This risk must be countered by
taking measures on site, such as using approach
rails for the load wheel arms.
It is the responsibility of the operating company
to identify and eliminate any danger areas and/or
to prohibit any reasonably foreseeable misuse by
issuing operating instructions.
The industrial truck is also suitable for raising,
lowering and transporting unit loads.
Use for other purposes is prohibited.
NOTE
There are also
variants of this order picker
that have a wa
lk-in order picking cage or an
order-picki
ng platform instead of the fork.
The auxiliary lift can be moved to a height that
is ideal for setting down and collecting items
for order picking.
Observe the instructions in the paragraph
"safety".
The maximum
load that can be lifted is speci-
fied on the loa
dbearing information plate (load
diagram) and
must not be exceeded.
If these industrial trucks are to be used for
tasks not listed in these operating instructions
or in the guidelines for the intended use of in-
20 5
212 804 3001 EN - 02/2017
To Next Page
Loading...
Need help?
General
