Using the truck
Commissioning
Commissioning is the initial intended use of
the truck.
The necessary steps for the commissioning
vary depending on the model and equipment
of the truck. These steps require preparatory
work and adjustment work that cannot be per-
formed by the operating company. See also
the chapter entitled "Definition of responsible
persons".
– To commission the truck, contact the au-
thorised service centre.
Intended use
The truck described in these operating instruc-
tions is suitable for lifting, transporting and
stacking loads.
The truck may only deployed for its intended
use as set out and described in these operat-
ing instructions.
If the truck is to be used for purposes other
than those specified in the operating instruc-
tions, the approval of the manufacturer and, if
applicable, the relevant regulatory authorities
must be obtained beforehand in order to pre-
vent hazards.
The maximum load to be lifted is specified on
the capacity rating plate (load diagram) and
must not be exceeded; see the section entitled
"Capacity rating plate" in the chapter entitled
"Handling loads".
Proper use during towing
This truck is suitable for the occasional tow-
ing of trailers and is equipped with a towing
device for this purpose. This occasional tow-
ing may not exceed 2% of the daily operating
time. If the truck is to be used for towing on
a more regular basis, the manufacturer should
be consulted.
Foreword
1
Using the truck
14 57378011527EN-12/2023 - 07
To Next Page
Loading...
