If a sensor belonging to Dynamic Load Con-
trol2 fails, the level of intervention from the
function is increased to a maximum. A cross
appears instead of the bar.
– If this display appears permanently, contact
the authorised service centre.
Load measurement (variant)
Knowing the weight of the load to be trans-
ported gives the driver greater security. If the
truck is equipped with the "load measurement"
assistance system, the weight of the lifted load
is measured and displayed in the display-op-
erating unit(1). The measuring accuracy is
5% of the rated capacity.
– Observe the following safety information.
DANGER
Risk of accident from a falling load!
The load may fall if the load centre of gravity has
not been taken into account or the load has not been
picked up securely.
– Pick up the load securely; see the chapter entitled
"Picking up loads".
WARNING
Risk of accident as a result of exceeding the residual
load capacity.
If the weight determined by a load measurement ex-
ceeds the permissible residual load capacity of the
truck, the truck cannot be operated safely.
– Set down and reduce the load immediately.
– If necessary, use another truck with sufficient
load-bearing capacity.
6219_003-112_V4
1,6 t
2,71 m
7,0°
Operation
4
Load-dependant assistance systems
27357378011527EN-12/2023 - 07
To Next Page
