CAUTION
Heavy roof loads damage the overhead guard!
To ensure the stability of the overhead guard at all
times, a roof load may only be mounted on the over-
head guard if the structural design has been tested
and the manufacturer has given approval.
– Seek advice from the authorised service centre for
the mounting of roof loads.
Warning about any manipulation
of the internal combustion en-
gine
The internal combustion engine used in this
truck possesses an EU type approval, which
is required for the legitimate operation of this
truck.
Manipulation of the internal combustion en-
gine in any way invalidates this EU type ap-
proval. In this case, operation of the truck is
also no longer permitted.
Warning regarding non-original
parts
Original parts, attachments and accessories
are specially designed for this truck. We spe-
cifically draw your attention to the fact that
parts, attachments and accessories supplied
by other companies have not been tested and
approved by STILL.
CAUTION
Installation and/or use of such products may there-
fore have a negative impact on the design features
of the truck and thus impair active and/or passive
driving safety.
We recommend that you obtain approval from the
manufacturer and, if necessary, from the relevant
regulatory authorities before installing such parts.
The manufacturer accepts no liability for any damage
caused by the use of non-original parts and accesso-
ries without approval.
Safety
2
Basic principles for safe operation
3357378011527EN-12/2023 - 07
To Next Page
Loading...
