Still RX70-35 - Checking the Brake System for Correct Function

Checking the brake system for
correct function
DANGER
Risk of accident due to failure of the brake system!
If the brake system fails, the truck will be insufficient-
ly braked or will not be braked at all.
– Do not operate the truck with a defective brake
system.
Checking the regenerative brake
DANGER
Risk of accident due to reduced braking power!
The braking effect of the regenerative brake may be
insufficient for emergency braking.
– Always press the brake pedal(2) for emergency
braking.
If the driving speed is restricted or if the op-
posite drive direction is selected, the truck is
braked using the regenerative brake.
– To actuate this, release the accelerator
pedal(1).
The truck must decelerate and remain station-
ary.
– If the truck does not slow down, press the
brake pedal(2).
Checking the service brake
– Release the parking brake.
– Press the brake pedal(1).
There must be a slight pedal clearance and
then a noticeable pressure point at the brake.
– Accelerate the unladen truck in a clear
area.
– Depress the brake pedal firmly.
The truck must decelerate noticeably.
1
2
5060_003-006

1
5060_003-015

Operation
4
Checks and tasks before daily use
 8557378011527EN-12/2023 - 07