Damage, defects and misuse of
safety systems
Damage or other defects on the truck or at-
tachment must be reported to the supervisor
or responsible fleet manager immediately so
that they can have the defect rectified.
Trucks and attachments that are not functional
or safe to drive may not be used until they
have been properly repaired.
Do not remove or deactivate safety systems
and switches.
Fixed set values may only be changed with
the approval of the manufacturer.
Work on the electrical system (e.g. connecting
a radio, additional headlights etc.) is only per-
mitted with the manufacturer's written appro-
val. All electrical system interventions must be
documented.
Even if they are removable, roof panels may
not be removed, as they are designed to pro-
tect against small falling objects.
Tyres
DANGER
Risk to stability!
Failure to observe the following information and in-
structions can lead to a loss of stability. The truck
may tip over, risk of accident!
The following factors can lead to a loss of
stability and are therefore
prohibited
:
●
Different tyres on the same axle, e.g. pneu-
matic tyres and superelastic tyres
●
Tyres not approved by the manufacturer
●
Excessive tyre wear
●
Tyres of inferior quality
●
Changing rim wheel parts
●
Combining rim wheel parts from different
manufacturers
Safety
2
Basic principles for safe operation
34 57378011527EN-12/2023 - 07
To Next Page
