Still RX70-35 - Messages about the Truck

Messages about the truck
If messages with a code appear on the dis-
play-operating unit, the truck control unit has
detected a fault. The message with a code is
stored in the message list until the cause of
the message is corrected. The saved messag-
es can be called up from the "message list".
If, for example, the reflector or the lift-height
sensor is contaminated, it usually helps to
clean these components.
– Switch the truck off and on again.
– If the message still appears, please contact
the authorised service centre.
The messages are sorted in ascending order according to their code:
Code Shown on display Description/possible solution
A2103 Parameter faulty  Collective fault of the parameters
A2305
Fault: Control unit  Collective fault on the control unit
A2545
Actuator error 9: 
Actuator breakdown
If no attachment is fitted, this message can be
ignored.
- If there is an attachment fitted, contact the
authorised service centre.
A2801
Monitoring  Process monitoring, proc1
A2802
Monitoring  Process monitoring, proc2
A2803
Monitoring  Process monitoring, proc3
A2804
Monitoring  Process monitoring, proc4
A2805
Monitoring  Process monitoring, proc5
A2806
Monitoring  Process monitoring, proc6
A2807
Monitoring  Process monitoring, proc7
A2808
Monitoring  Process monitoring, proc8
A2809
Monitoring  Process monitoring, proc9
A2810
Monitoring  Process monitoring, proc10
A2811
Monitoring  Process monitoring, proc11
A2899
Monitoring  Collective fault of the process monitoring
A3015
Fault: Brake sensor  Collective fault on the brake sensor
A3027
Fault: Seat switch 
The seat switch does not open
- Stand up from the driver's seat and sit down
again.
A3035
Fault: Brake fluid  Brake fluid switch
A3143
Check lift height sensor
and reflector

Lift-height sensor measurement error
Operation
4
Display messages
 370 57378011527EN-12/2023 - 07