Checks and tasks before daily use
Visual inspections and function checking
WARNING
Risk of injury from falling off the truck!
When climbing onto the truck, there is
a risk of getting stuck or slipping and
falling. Use suitable equipment to reach
higher points on the truck.
– Use only the steps provided for this
purpose to climb onto the truck.
– Use equipment such as stepladders
or platforms to reach inaccessible
areas.
Damage to the truck or the attachment
(variant), non-functional switches or safe-
ty systems and modification of predefined
set values can lead to unpredictable and
dangerous situations.
The following checks and tasks enable
causes of this type to be identified in
good time. It is important to run through
all the checks and tasks listed in the fol-
lowing table from top to bottom before
daily use of the truck.
If damage or other defects are identified
on the truck or the attachment (variant),
the truck must not be used until it has
been properly repaired.
Ensure that the truck is safe for operation each day before it is used:
Component Course of action
Fork arms, general lifting accessories
Perform a visual inspection to check for deformation
and wear (e.g. to check if they are bent, broken or
feature significant wear).
Check the condition and function of the fork locking
devices for preventing lifting and shifting.
Lift mast roller tracks Make sure that there is a film of grease.
Load chains
Perform a visual inspection to ensure that the
chains are intact and have adequate and even ten-
sion.
Operation
4
Checks and tasks before daily use
78 57378011527EN-12/2023 - 07
To Next Page
