Example:
If the values above have been configured, the ip show command will give the following result
(interface 1 is the LAN interface, interface 2 is not used, and interface 3 is the DVB (satellite)
interface):
#
ip show
Interfaces
If IPAddress SubnetMask BroadCastAddr MTU Alias
AdminStatus
1 10.20.42.1 255.255.255.0 10.20.42.255 1500 eth0 1
2 N/A N/A N/A 4074 air0 1
3 10.42.0.42 255.255.255.255 10.42.0.42 4074 dvb0 1
DNS Client Configuration
Primary DNS Server: 213.42.20.20, Secondary DNS Server:
Interface Statistics
------------- Input ----------------- ------------- Output ----------------
If UCast NUCast Disc Octets UCast NUCast Disc Octets
1 4354 7226 6060 831931 103 99 0 18381
2 0 0 0 0 0 0 0 0
3 696 0 0 66518 5038 0 0 389150
IP Receive Deliver Errors Discards Forward Request NoRoute Discards
5797 1379 0 0 4418 805 0 4
Interface Directed Routing Table
In If Out If
Routing Table
DestMask RouteMask NextHop If
0.0.0.0 0.0.0.0 0.0.0.0 3
10.20.42.0 255.255.255.0 0.0.0.0 1
10.42.0.42 255.255.255.255 0.0.0.0 3
4) Save the IP configuration to Flash memory
– Enter the CLI command: save config
Example:
# save config
Saving Configuration. This will take ~20 secs
# Configuration Saved
#
If the prompt sign (#) does not show, press <ENTER>.
H.2 DNS Configuration
The DNS server the SatLink VSAT uses is normally configured automatically by the SatLink Hub. For a
system where this is not done, the primary and, optionally, secondary DNS server IP addresses can be
configured using the CLI command ip dns server.
To Next Page
Loading...