Figure 30: Satellite Interface Status
6.6 Prepare the VSAT for Normal Operation
The connection to the Internet over the satellite network should now be tested and found to be working.
The only thing left is then the final configuration to prepare the VSAT for normal operation. The VSAT
must be started and a user must be logged in with a minimum privilege level of 2 (e.g., install user)
before completing the following operations.
1) Click on the Satellite option under Configuration in the SatLink VSAT home page and Configure the
VSAT to automatically start the receiver by setting Auto Start to ―ON‖. The VSAT will automatically
acquire the Forward Link. Setting the RX auto start to ―ON‖ will ensure that the receiver is started
automatically after power failure, link failure, Hub restart, or a software failure, etc., without needing
user intervention.
To Next Page
Loading...