STM SatLink VSAT - Summary of Available CLI Commands

SatLink VSAT User Guide
Publication no. 101557
Rev 14.1.1-2
Copyright 2006-2012 – STM Group, Inc.
Page 47 (182)
Events with severity level Major will normally cause disruption in the data transfer, while events with
severity level Critical normally will require user intervention in order to restore the data communication
with the DVB-RCS Hub.
To have access to the log of events after the VSAT software has been rebooted, the event above a
specified severity level can be logged to file. Use the CLI command log file to enable logging of
events to file, set the minimum severity level of events that shall be logged to file, and set the maximum
size for the logfile. By default, Major and Critical events are logged to file.
8.4 CLI Command Summary
The available CLI commands are listed below.
CLI commands
Available
in Boot
SW
Available in
Application
SW
User
Privilege
Level
? [sub-menu] [cmd]
x
x
5
del <filename>
x
x
2
ren <filename1> <filename2>
x
x
2
mv <filename1> <filename2>
type <filename>
setrows <row-number>
x
x
2
dir [ext]
x
x
5
type <filename>
x
x
5
dload <filename> <ipaddr> [<localname>]
x
x
2
upload <filename> <ipaddr> [<remotename>]
x
x
3
ping {<ipaddr> [<options>]}|-stop|<-
enablemonitor|disablemonitor
x
x
5
exit
x
x
5
logout
x
x
5
restart
x
x
3
save config
arp flush <all | static | dynamic>
arp show
x
x
x
3
3
5
device snmp show
x
1
device snmp community <name> <ro|rw>
[<ipaddr> <mask>]
x
1
device snmp delcommunity <name>
x
1
device manager show
x
1
device manager add <func> <if> [<ip> <mask>]
x
1
device manager del <func> <if> [<ip> <mask>]
device manager httpport <port>
x
1
device name <name>
x
2
device contact <contact>
x
2
device location <location>
x
2
device show [-dvbs2]
x
5
device telnet show [-session id]
x
5
device telnet disconnect <session id>
x
1
dvb atmmode <mode>
x
2
dvb hdrcomp <mode> |-show
dvb cr capacity <crClass> <CRA> <RBDCMax>
<VBDCMax>
dvb cr timeout <RBDCtimeout VBDCtimeout>
dvb cr interval [-vbdc <interval>]
dvb cr show [-timeout|-interval|-capacity]
x
2