6. SatLink VSAT Configuration and Line-up Using the Web
Interface
Follow all the procedures mentioned below when installing the SatLink VSAT and lining up the ODU
using the Web interface. Please see section 7 for SatLink VSAT status monitoring using the web
interface.
6.1 Log On to the VSAT Web Interface
1) Start the web browser and type in the IP address of the VSAT in the address field.
2) Login with username install and factory default password dvbrcs. Click the OK button.
Username: install
Password: dvbrcs
Figure 19: Log on Page
6.2 Configuring VSAT Parameters Required to Log on to the Hub
The SatLink VSAT Web interface is used to configure a number of parameters before the VSAT can
acquire the Forward Link and communicate with the Hub via the satellite connection. A default
configuration specifying most of these parameters is pre-loaded on each VSAT, either in the factory or by
the service provider before installation. The following configuration parameters are typically to be
configured using the VSAT Web interface:
DVB-S2 Reception parameters
VSAT GPS Position
Other parameters are typically configured automatically from the Hub when the VSAT logs on for the
first time. When ODUs other than the SatLink 403x transceiver are used or if the Hub operator does not
use automatic VSAT configuration, then additional VSAT parameters might have to be configured during
installation.
To Next Page
Loading...