Publication no. 101557
Rev 14.1.1-2
Copyright 2006-2012 – STM Group, Inc.
16. Updating the VSAT SW
The flash in the VSAT can store two SW images, both the currently used SW and a backup version in
case download of a new SW version fails.
Note that different VSAT models require different software images to be downloaded.
Please make sure correct SW image / file name is used for given VSAT model as specified
in the table below.
satlink-vsat2-X.Y.Z.B.tgz
satlink-vsat2-X.Y.Z.B.tgz
Table 14: Application SW filename to use for different VSAT models
―X.Y.Z‖ in the application SW file name is the actual release number, e.g. ―14.0.0‖ and B is the build
number for the SW release.
Always use the command sw upgrade as described in section 16.2 to manually upgrade
the software version of a VSAT, since this command automatically deletes old backup
software versions and backs up the current software and the configuration.
Do not use the CLI command dload to upgrade the software of the VSAT, since failure to
delete old backup software version may block future automatic software upgrades.
To Next Page
Loading...