STM SatLink VSAT - 7 Status Monitoring Using the Satlink Web Interface; Satellite Interface Status

SatLink VSAT User Guide
Publication no. 101557
Rev 14.1.1-2
Copyright 2006-2012 – STM Group, Inc.
Page 39 (182)
7. Status Monitoring Using the SatLink Web Interface
The SatLink web interface is used to display the status of the SatLink VSAT. An operator can view the
status information of the satellite interface, packet and burst statistics, device information, the status of the
DHCP server, and the status of mesh and terminal burst receiver.
7.1 Satellite Interface Status
The satellite option provides an overview of the status on the satellite interface, such as the state,
transmitter and receiver. Select the Satellite option under Status on the SatLink web interface home page
to open the Satellite Interface Status page.
Figure 33: Satellite Receiver Status
Parameter
Description
State
Specifies the state of the satellite (DVB) interface. During normal operation, it reads ―Two-way link
established‖.
Transmitter
This determines the transmitter status. During normal operation, it reads ―On‖.
Receiver
This specifies the receiver status. During normal operation, it reads ―On‖.