MAC addresses
--------------------------------
Ethernet (LAN) : 00:60:c0:2f:ba:83
Satellite (DVB) : 00:60:c0:2f:ba:83
When the card has been detected by the VSAT, the DVB-S2 connection is configured the same as DVB-
S, as described in section 9.2.3.
Example:
# dvb rx fwdlink 0 0 25000000 12380000 dvbs2 2
# save config
# dvb rx show
Satellite (DVB) RX Configuration
--------------------------------
Auto start : Disabled
Idx Pri Freq[GHz] SymbRate[Msps] Mode PopId
* 0 0 12.380000 25.000000 DVB-S2 2
DVB Receiver Status (SatLink 100)
--------------------------------
Rx State : On
DVB State : Forward Link up
Network : 1326, STM Spain
Frequency : 12.380887 GHz
Symbol Rate : 24.999998 Msps
S2 ModCod : 13 8PSK-2/3
Pilot : On
Frame length : Long frame
DVB S2 Mode : CCM
Roll off : 0.35
SNR : 15.2 dB
For SatLink 1910 and 1000 having revision 2.0 or newer, there is no need for the SatLink 100 plug-in
card, as they have built-in DVB-S2 receive capabilities as default. Both models are configured the same
way as the example shows above.
If there is any doubt on whether a SatLink VSAT is capable of receiving DVB-S2, issue the CLI
command device show -dvbs2.
Example:
# device show -dvbs2
DVB-S2 capability
This device supports DVB-S2 CCM and ACM.
HW revision
STV0900 receiver cut 2.0
To Next Page
Loading...