Strauss water Bubble PLUS - CO Cylinder Content; Internal Cleaning; Maintenance after a Prolonged Period of Time

29
h. CO
2
cylinder content
This option enables checking the CO
2
cylinder content.
To check the contents of the CO
2
cylinder enter the CO
2
CYLINDER STATUS
sub menu:
MENU MAINTENANCE CO
2
CYLINDER STATUS
The cylinder status will appear on the display:
Blue indicates a 5-100% full cylinder. Red indicates 5% CO
2
left in the
cylinder
Please note! When the CO
2
cylinder is completely empty, the system will
discharge it completely so the cylinder can be removed. Do not release the CO
2
cylinder before it is discharged in a controlled manner, and a message that the
CO
2
cylinder can be replaced appears on the display.
i. Internal Cleaning
The option enables performing an internal cleaning using the system cleaning
capsules .
To perform the internal cleaning, enter the INTERNAL CLEANING sub menu:
MENU MAINTENANCE INTERNAL CLEANING
To start the cleaning process press the OK button.
The water bar will start the cleaning process. Follow the instructions on the
display until the cleaning process is complete.
Important! The cleaning process takes approximately 30 min and involves
dispensing hot water. The water bar cannot be used until the cleaning process is
complete.
j. Maintenance After a Prolonged Period of Time
When the water bas is not going to be used for more than 3 days, disconnect
the water bar from the electricity supply and turn off the water tap. The next
time the water bar is used, dispense cold water for approximately 1 minute, hot
water for approximately 2 minutes and 2 cups of sparkling water.
CO
2
CYLINDER STATUS
FULL
EMPTY
FULL
EMPTY
CO
2
CYLINDER STATUS