33
7. Replacement Date for the CO
2
Cylinder
When the CO
2
cylinder is completely empty, a controlled discharging process
will be performed by the water bar. During this process the remaining CO
2
in
the cylinder is emptied into the water bar and may be accompanied by noise.
Please note! Do not remove the CO
2
cylinder before the controlled
discharging process is completed.
The process starts automatically immediately following the dispensing of the
last cup of sparkling water.
> During the cylinder discharging process, the water bar display will indicate
that the water bar has started the discharging process. Do not perform any
actions on the CO
2
cylinder until the water bar displays that the action is
complete and the cylinder can be replaced.
> During the discharging process, the sparkling water icon will be dimmed and
dispensing sparkling water will not be possible.
> A blue progress bar will be displayed above the icon and show the CO
2
cylinder emptying progress rate.
> At the end of the process, the message CO
2
CYLINDER PROCESS COMPLETED
will appear, an empty CO
2
icon will be displayed and the message PLEASE
REPLACE THE CO
2
CYLINDER will be displayed.
> Now you can remove the old CO
2
cylinder and replace it with a new one.
> As soon as the replacement has been completes, the empty cylinder icon will
disappear and it will be possible to dispense sparkling water.
Please note! If the CO
2
cylinder is not replaced, the CO
2
cylinder icon will
appear on the main screen and the sparkling water cup icon on the display will
be dimmed. In this state, attempting to dispense sparkling water will show an
alert on the display for 3 seconds accompanied by a beep.
For an explanation on replacing the CO
2
cylinder, see section "8. Replacing the
CO
2
Cylinder" on page 34.
To order CO
2
cylinders, contact the customer service center.
To Next Page
Loading...
